Zero Point Calibration

PERFORM YAW RATE AND ACCELERATION SENSOR AND STEERING ANGLE SENSOR ZERO POINT CALIBRATION (When Using SST Check Wire)



NOTICE:



* While obtaining the zero points, keep the vehicle stationary and do not vibrate, tilt, move, or shake it (do not start the engine).

* Be sure to perform this procedure on a level surface (with an inclination of less than 1%).



(a) Clear the zero point calibration data.



(1) Turn the ignition switch off.



(2) Check that the steering wheel is centered.



(3) Check that the shift lever is in P.



(4) Turn the ignition switch to ON.



(5) The ABS warning light and slip indicator light come on for 3 seconds to indicate that the initial check is completed.



(6) Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.



Front view of DLC3





(7) Check that the slip indicator light comes on.



(b) Perform zero point calibration of the yaw rate and acceleration sensor.



(1) Turn the ignition switch off.



(2) Check that the steering wheel is centered.



(3) Check that the shift lever is in P.







(4) Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.



Front view of DLC3





(5) Turn the ignition switch to ON.



(6) Keep the vehicle stationary on a level surface for 5 seconds or more.



(7) Check that the slip indicator light comes on for several seconds and then blink in the test mode pattern (0.125 seconds on and 0.125 seconds off).





(8) Turn the ignition switch off and disconnect SST from the DLC3.



(c) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds.









4. PERFORM DOWNHILL ASSIST CONTROL CALIBRATION (w/ Downhill Assist Control)



(b) Enter test mode (when using SST check wire).



(1) Turn the ignition switch off.



(2) Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.



Front view of DLC3





(c) Turn the downhill assist control switch off.



(d) Push the downhill assist control switch and check that the downhill assist control indicator light is blinking.



(e) Turn the downhill assist control switch off.



(f) Turn the ignition switch off.



(g) Check if DTC C120A is output.



HINT:



If DTC C120A is not output, calibration was performed successfully.









5. PERFORM CRAWL CONTROL CALIBRATION (w/ Crawl Control)



(2) Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.



Front view of DLC3









(c) Push the crawl ON/OFF switch and check that the crawl indicator light is on while the switch is being pushed.



Text in Illustration





*1 Crawl Control Switch



*2 ON/OFF Switch



*3 Speed Selector Switch



*4 Low



*5 Medium-low



*6 Medium



*7 Medium-high



*8 High







(d) Turn the crawl ON/OFF switch off.



(e) Turn the speed selector switch to L (low).



(f) Turn the speed selector switch to medium-low.



(g) Turn the speed selector switch to M (medium).



(h) Turn the speed selector switch to medium-high.



(i) Turn the speed selector switch to H (high).



(j) Turn the speed selector switch to L (low).



(k) Turn the ignition switch off.



(l) Check if DTC C120A is output.



HINT:



If DTC C120A is not output, calibration was performed successfully.